Stanislaw GruszkaandFelix Fietkau 88f68838d9 mt76: remove wait argument from mt76x02_mcu_calibrate ...

We always wait for CMD_CALIBRATION_OP mcu message, but wait argument is used
for do additional MT_MCU_COM_REG0 register operations, which are needed
for mt76x2e devices and we can use appropriate check instead of wait argument.

Signed-off-by: Stanislaw Gruszka <[email protected]>

2018-11-13 20:56:41 +01:00

firmware

add mt7610e firmware

2018-10-16 12:53:43 +02:00

mt76x0

mt76: remove wait argument from mt76x02_mcu_calibrate

2018-11-13 20:56:41 +01:00

mt76x2

mt76: remove wait argument from mt76x02_mcu_calibrate

2018-11-13 20:56:41 +01:00

mt7603

mt7603: simplify mt7603_mcu_msg_send, remove skb_ret handling

2018-11-13 14:53:45 +01:00

.gitignore

add .gitignore

2015-12-13 17:54:16 +01:00

agg-rx.c

treewide: Use struct_size() for kmalloc()-family

2018-09-12 13:18:26 +02:00

debugfs.c

mt76: move rate_txpower handler in mt76 debugfs

2018-09-26 22:04:27 +02:00

dma.c

mt76: do not wake tx queues during flush

2018-11-09 13:44:02 +01:00

dma.h

mt76x02: move TXD/RXD/MCU definitions in mt76x02_dma.h

2018-09-12 13:16:50 +02:00

eeprom.c

revert mt76_eeprom_override call reordering

2017-02-03 14:25:08 +01:00

mac80211.c

mt76: add mt76_sta_remove helper

2018-11-13 11:33:48 +01:00

Makefile

mt76: move dfs support in mt76x02-lib module

2018-10-23 11:14:20 +02:00

mmio.c

mt76: allow to identify bus

2018-10-08 13:47:02 +02:00

mt76.h

mt76: add mt76_sta_remove helper

2018-11-13 11:33:48 +01:00

mt76x02_debugfs.c

mt76: move mt76x02_debugfs in mt76x02-lib module

2018-10-16 12:51:14 +02:00

mt76x02_dfs.c

mt76x0: dfs: fix IBI_R11 configuration on non-radar channels

2018-11-05 10:21:24 +01:00

mt76x02_dfs.h

mt76x0: pci: add DFS support

2018-10-23 11:14:20 +02:00

mt76x02_dma.h

mt76: move tx_tasklet management in mt76x02-lib moudle

2018-10-05 20:03:54 +02:00

mt76x02_eeprom.c

mt76: move mt76x02_eeprom_copy in mt76x02-lib module

2018-11-01 18:04:15 +01:00

mt76x02_eeprom.h

mt76x0: phy: introduce tssi calibration support

2018-11-01 18:04:15 +01:00

mt76x02_mac.c

mt76: avoid queue/status spinlocks while passing tx status to mac80211

2018-11-05 21:11:42 +01:00

mt76x02_mac.h

mt76: add support for reporting tx status with skb

2018-10-25 18:27:55 +02:00

mt76x02_mcu.c

mt76: remove wait argument from mt76x02_mcu_calibrate

2018-11-13 20:56:41 +01:00

mt76x02_mcu.h

mt76: remove wait argument from mt76x02_mcu_calibrate

2018-11-13 20:56:41 +01:00

mt76x02_mmio.c

mt76x0: pci: add pre_tbtt_tasklet support

2018-10-23 11:13:45 +02:00

mt76x02_phy.c

mt76x02: run calibration after scanning

2018-11-01 18:29:27 +01:00

mt76x02_phy.h

mt76: introduce mt76x02_init_agc_gain routine

2018-10-15 14:03:01 +02:00

mt76x02_regs.h

mt76x0: correct RF access via RF_CSR register.

2018-10-08 13:47:02 +02:00

mt76x02_trace.c

mt76: move mt76x02_mac_poll_tx_status in mt76x02-lib moudle

2018-10-05 20:00:30 +02:00

mt76x02_trace.h

mt76: move irq handler in mt76x02-lib moudle

2018-10-05 20:03:54 +02:00

mt76x02_txrx.c

mt76: add support for reporting tx status with skb

2018-10-25 18:27:55 +02:00

mt76x02_usb_core.c

mt76: add support for reporting tx status with skb

2018-10-25 18:27:55 +02:00

mt76x02_usb_mcu.c

mt76: remove mcu_msg_alloc

2018-11-01 18:04:33 +01:00

mt76x02_usb.h

mt76: use mt76x02_dev instead of mt76_dev in mt76x02_mac.c

2018-10-08 13:47:02 +02:00

mt76x02_util.c

mt76x0: pci: enable VHT rates in IBSS mode

2018-11-13 20:56:41 +01:00

mt76x02.h

mt76: introduce mt76x02_config_mac_addr_list routine

2018-11-13 20:56:41 +01:00

trace.c

update my email address

2016-09-04 17:33:28 +02:00

trace.h

core: rename register trace events to avoid conflict with mt7601u

2016-09-05 11:29:58 +02:00

tx.c

mt76: request tx status for powersave released EOSP packet

2018-11-13 20:54:19 +01:00

usb_mcu.c

mt76: usb: move mt76x02 mcu code in mt76x02-usb module

2018-09-12 13:16:24 +02:00

usb_trace.c

mt76: add usb support to mt76 layer

2018-09-11 13:49:19 +02:00

usb_trace.h

mt76: usb: fix static tracepoints

2018-10-23 09:49:40 +02:00

usb.c

mt76: add support for reporting tx status with skb

2018-10-25 18:27:55 +02:00

util.c

adjust MODULE_LICENSE for license change

2016-09-05 11:34:38 +02:00

util.h

move mt76_insert_hdr_pad to mt76x2_tx.c

2016-09-04 18:06:48 +02:00

S

Description

mac80211 driver for MediaTek MT76x0e, MT76x2e, MT7603, MT7615, MT7628 and MT7688

BSD-3-Clause

105 MiB

Languages

C 99.7%

Perl 0.2%

Makefile 0.1%