Remove obsoleted codes. This is the preparation for .set_bitrate_mask().
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
"idx" needs to be signed for the error handling to work.
Fixes: 495184ac91bb ("mt76: mt7915: add support for applying pre-calibration data")
Signed-off-by: Dan Carpenter <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Instead of attaching the last reported rate to tx packets, use
ieee80211_tx_status_ext to immediately pass the rate to mac80211 after
receiving it from the firmware.
Preparation for implementing full tx status reporting
Signed-off-by: Felix Fietkau <[email protected]>
Use ieee80211_tx_status_ext instead of ieee80211_free_skb and
ieee80211_tx_status. This makes it compatible with 802.3 encap offload
and improves performance by removing a redundant sta lookup
Signed-off-by: Felix Fietkau <[email protected]>
As already done for mt7615 and mt7915, enable rx header translation
offload for mt7921 in order to reduce cpu load in the rx path.
Signed-off-by: Lorenzo Bianconi <[email protected]>
Enable hw rx-amsdu de-aggregation support available in 7921 devices.
This is a preliminary patch to enable rx checksum offload.
Signed-off-by: Lorenzo Bianconi <[email protected]>
The hardware can only handle 64 subframes in rx direction and 128 for tx.
Improves throughput with APs that can handle more than that
Signed-off-by: Felix Fietkau <[email protected]>
Remove MT76_STATE_PM in mt7615_init_device() and introduce
__mt7663s_mcu_drv_pmctrl for fw loading in mt7663s.
This patch fixes a crash at bootstrap for device (e.g. mt7622) that do
not support runtime-pm
Fixes: 129fac01ffe85 ("mt76: connac: introduce wake counter for fw_pmctrl synchronization")
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Do not run ieee80211_queue_delayed_work for mac work if the worqueue is
not initialized yet
Fixes: b1bd7bb8121d ("mt76: connac: unschedule mac_work before going to sleep")
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Fix possible array out of bound access in mt7921_mcu_tx_rate_report.
Remove unnecessary varibable in mt7921_mcu_tx_rate_report
Fixes: 1c099ab44727c ("mt76: mt7921: add MCU support")
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Check dummy reg to reinitialized WPDMA during driver_own operation
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
In order to remove duplicated code, move mt76_token_init in
mt76_alloc_device routine
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Precision %.*s was intended instead of width %*s. The original code
is potentially an information leak.
Fixes: c7cc5ec57303 ("mt76: mt7921: rework mt7921_mcu_debug_msg_event routine")
Signed-off-by: Dan Carpenter <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Precision %.*s was intended instead of width %*s. The original code
will still print unintended data from beyond the end of skb->data.
Fixes: 665b2c780d63 ("mt76: mt7915: limit firmware log message printk to buffer length")
Signed-off-by: Dan Carpenter <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Precision "%.*s" was intended instead of width "%*s". The original code
will print garbage from beyond the end of the skb->data.
Fixes: d76d6c3ba2b0 ("mt76: mt7615: limit firmware log message printk to buffer length")
Signed-off-by: Dan Carpenter <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
mt7921_mcu_sta_add will be used to add and remove wtbl entries.
Create broadcast wtbl entry after AP association
Co-developed-by: Deren Wu <[email protected]>
Signed-off-by: Deren Wu <[email protected]>
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
mt7921_stop should put device in fw_own state to reduce
power consumption.
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
In order to wake the device less frequently and so reduce power
consumpation, unschedule mac_work before going to sleep
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Similar to mt7921, introduce awake and doze time accounting
for runtime pm.
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Increase mt7921 mac work timeout in oder to have move sleep
opportunities
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
since mcu_reset it used only by mt7921, move the reset callback to
mt7921_mcu_parse_response routine and get rid of the function pointer.
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Do not read rf value from efuse when driver is configured to
use flash mode.
Tested-by: Bruce Chuang <[email protected]>
Signed-off-by: Shayne Chen <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Move token management in mt76 common module since it is shared between
mt7615, mt7915 and mt7921 drivers
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Move token_lock, token and token_count data structures in mt76_dev.
This is a preliminary patch to move token management in mt76 common
module since it is shared by mt7615, mt7915 and mt7921 drivers.
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Enable the deep sleep mode in suspend handler to reduce the power
consumption further.
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Introduce mt76_connac_mcu_set_deep_sleep to enable deep sleep mode
and will be activated immediately when the host returns the ownership
to the device.
Co-developed-by: Leon Yen <[email protected]>
Signed-off-by: Leon Yen <[email protected]>
Co-developed-by: YN Chen <[email protected]>
Signed-off-by: YN Chen <[email protected]>
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Introduce mt7921_dma_enable and mt7921_dma_disable utilities routine in
order for code reusing between mt7921_dma_reset and mt7921_dma_init.
This is a preliminary patch to reset dma during device driver_own
request.
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Introduce mt7921_wpdma_reset routine to reset wpdma during chip reset
or driver_own request.
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Move mt7921_dma_reset routine in dma.c and make mt7921_dma_prefetch
static. Moreover add force parameter to mt7921_dma_reset signature.
This is a preliminary patch to reset dma mt7921_mcu_drv_pmctrl.
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Currently the assignment of idx dereferences pointer sta before
sta is null checked, leading to a potential null pointer dereference.
Fix this by assigning idx when it is required after the null check on
pointer sta.
Addresses-Coverity: ("Dereference before null check")
Fixes: a4a5a430b076 ("mt76: mt7615: fix TSF configuration")
Signed-off-by: Colin Ian King <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Enable sw interrupts in order to wake the device from deep sleep
receiving packets
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
