In vendor driver, size of group cal and dpd cal for mt7981 includes 6G
although the chip doesn't support it.
mt76 doesn't take this into account which results in reading from the
incorrect offset.
For devices with precal, this would lead to lower bitrate.
Fix this by aligning groupcal size with vendor driver and switch to
freq_list_v2 in mt7915_dpd_freq_idx in order to get the correct offset.
Below are iwinfo of the test device with two clients connected
(iPhone 16, Intel AX210).
Before :
Mode: Master Channel: 36 (5.180 GHz) HT Mode: HE80
Center Channel 1: 42 2: unknown
Tx-Power: 23 dBm Link Quality: 43/70
Signal: -67 dBm Noise: -92 dBm
Bit Rate: 612.4 MBit/s
Encryption: WPA3 SAE (CCMP)
Type: nl80211 HW Mode(s): 802.11ac/ax/n
Hardware: embedded [MediaTek MT7981]
After:
Mode: Master Channel: 36 (5.180 GHz) HT Mode: HE80
Center Channel 1: 42 2: unknown
Tx-Power: 23 dBm Link Quality: 43/70
Signal: -67 dBm Noise: -92 dBm
Bit Rate: 900.6 MBit/s
Encryption: WPA3 SAE (CCMP)
Type: nl80211 HW Mode(s): 802.11ac/ax/n
Hardware: embedded [MediaTek MT7981]
Tested-on: mt7981 20240823
Fixes: 19a954edec63 ("wifi: mt76: mt7915: add mt7986, mt7916 and mt7981 pre-calibration")
Signed-off-by: Zhi-Jun You <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
Move the NULL check for 'sta' before dereferencing it to prevent a
possible crash.
Fixes: 44eb173bdd4f ("wifi: mt76: mt7925: add link handling in mt7925_txwi_free")
Signed-off-by: Ming Yen Hsieh <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
Check for a NULL `vif` before accessing `ieee80211_vif_is_mld(vif)` to
avoid a potential kernel panic in scenarios where `vif` might not be
initialized.
Fixes: ebb1406813c6 ("wifi: mt76: mt7925: add link handling to txwi")
Signed-off-by: Ming Yen Hsieh <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
Introduce rx_rro_ind_process and rx_rro_add_msdu_page callbacks and the
related logic in the MT7996 driver. This is a preliminary patch to
decouple RRO logic from WED support and reuse RRO when WED module is not
available.
Signed-off-by: Rex Lu <[email protected]>
Co-developed-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Lorenzo Bianconi <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
In order to properly set the number of rx packets for primary WED device
if hif device is available, move hif pointer initialization before
running mt7996_mmio_wed_init routine.
Fixes: 83eafc9251d6d ("wifi: mt76: mt7996: add wed tx support")
Signed-off-by: Lorenzo Bianconi <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
Introduce the second WDMA RX ring in WED driver for MT7988 SoC since the
Mediatek MT7992 WiFi chipset supports two separated WDMA rings.
Add missing MT7988 configurations to properly support WED for MT7992 in
MT76 driver.
Co-developed-by: Rex Lu <[email protected]>
Signed-off-by: Rex Lu <[email protected]>
Signed-off-by: Lorenzo Bianconi <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Jakub Kicinski <[email protected]>
Embedding net_device into structures prohibits the usage of flexible
arrays in the net_device structure. For more details, see the discussion
at [1].
Un-embed the net_devices from struct mt76_dev by converting them
into pointers, and allocating them dynamically. Use the leverage
alloc_netdev_dummy() to allocate the net_device object at
mt76_dma_init().
The free of the device occurs at mt76_dma_cleanup().
Link: https://lore.kernel.org/all/[email protected]/ [1]
Reviewed-by: Simon Horman <[email protected]>
Signed-off-by: Breno Leitao <[email protected]>
Acked-by: Kalle Valo <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Jakub Kicinski <[email protected]>
Any station configured with an AID over 20 causes a firmware crash.
This situation occurred in our testing using an AP interface on 7922
hardware, with a modified hostapd, sourced from Mediatek's OpenWRT
feeds.
In stock hostapd, station AIDs begin counting at 1, and this
configuration is prevented with an upper limit on associated stations.
However, the modified hostapd began allocation at 65, which caused the
firmware to crash. This fix does not allow these AIDs to work, but will
prevent the firmware crash.
This crash was only seen on IFTYPE_AP interfaces, and the fix does not
appear to have an effect on IFTYPE_STATION behavior.
Fixes: 5c14a5f944b9 ("mt76: mt7921: introduce mt7921e support")
Signed-off-by: Rory Little <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
Enable 160MHz beamformee support on mt7922 by updating HE capability
element configuration. Previously, only 160MHz channel width was set,
but beamformee for 160MHz was not properly advertised. This patch
adds BEAMFORMEE_MAX_STS_ABOVE_80MHZ_4 capability to allow devices
to utilize 160MHz BW for beamforming.
Tested by connecting to 160MHz-bandwidth beamforming AP and verified
HE capability.
Signed-off-by: Quan Zhou <[email protected]>
Link: https://patch.msgid.link/ae637afaffed387018fdc43709470ef65898ff0b.1756383627.git.quan.zhou@mediatek.com
Signed-off-by: Felix Fietkau <[email protected]>
Due to hibernation causing a power off and power on,
this modification adds mt7925_pci_restore callback function for kernel.
When hibernation resumes, it calls mt7925_pci_restore to reset the device,
allowing it to return to the state it was in before the power off.
Signed-off-by: Jack Kao <[email protected]>
Signed-off-by: Ming Yen Hsieh <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
Packets belonging to the same TID can be sent over multiple links.
AMPDU rx reordering must be performed over all active links. Fix the
problem always using default link for AMPDU rx reordering.
Signed-off-by: Lorenzo Bianconi <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
MT7925 is a connac3 device; using the connac2 helper mis-parses
TXWI and breaks AMPDU/BA accounting. Use the connac3-specific
helper mt7925_tx_check_aggr() instead,
Cc: [email protected]
Fixes: c948b5da6bbe ("wifi: mt76: mt7925: add Mediatek Wi-Fi7 driver for mt7925 chips")
Reported-by: Nick Morrow <[email protected]>
Tested-by: Nick Morrow <[email protected]>
Tested-on: Netgear A9000 USB WiFi adapter
Signed-off-by: Ming Yen Hsieh <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Felix Fietkau <[email protected]>
Never leave scheduled wcid entries on the temporary on-stack list
Fixes: 0b3be9d1d34e ("wifi: mt76: add separate tx scheduling queue for off-channel tx")
Signed-off-by: Felix Fietkau <[email protected]>
Avoid leaking them or keeping the wcid on the tx list
Fixes: 0b3be9d1d34e ("wifi: mt76: add separate tx scheduling queue for off-channel tx")
Signed-off-by: Felix Fietkau <[email protected]>
Since stations are recreated from scratch, all lists that wcids are added
to must be cleared before calling ieee80211_restart_hw.
Set wcid->sta = 0 for each wcid entry in order to ensure that they are
not added again before they are ready.
Signed-off-by: Felix Fietkau <[email protected]>
Non-station wcid entries must not be passed to the rx functions.
In case of the global wcid entry, it could even lead to corruption in the wcid
array due to pointer being casted to struct mt7996_sta_link using container_of.
Fixes: 7464b12b7d92 ("wifi: mt76: mt7996: rework mt7996_rx_get_wcid to support MLO")
Signed-off-by: Felix Fietkau <[email protected]>
When a wcid can't be found, link_sta can be stale from a previous batch.
The code currently assumes that if link_sta is set, wcid is also non-zero.
Fix wcid NULL pointer dereference by resetting link_sta when a wcid entry
can't be found.
Fixes: 62da647a2b20 ("wifi: mt76: mt7996: Add MLO support to mt7996_tx_check_aggr()")
Signed-off-by: Felix Fietkau <[email protected]>
