Introduce mt7615_poll_rx rx napi callback for mt7663.
Do not access device registers in tx/rx napi if the device is not awake.
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Add the capability to define a custom rx napi callback for each driver.
This is a preliminary patch to properly support runtime-pm on rx side
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Introduce mt7615_tx_worker routine as mt76 tx worker callback for
mt7663.
Rely on mt76_connac_pm_ref/mt76_connac_pm_unref to check PM state and
increment/decrement wake counter
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Introduce a mutex in order to avoid a race between mt7615_mcu_lp_drv_pmctrl and
mt7615_mcu_fw_pmctrl routines since they are run two independent works
Fixes: 1f549009b5b2 ("mt76: mt7615: do not request {driver,fw}_own if already granted")
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Move mt76_connac_mcu_update_arp_filter in mt76_connac module since the
code is shared between mt7615 and mt7921
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Dump mcu command code in hex and related prefix to help debugging
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
For MT7663, the availability of the patch files is used to detect, which
corresponding firmware is going to be used (AP firmware or STA offload
firmware). If the ROM patch was already applied, it could attempt to
load the wrong firmware (without considering the alternative).
Signed-off-by: Felix Fietkau <[email protected]>
MT7663 uses different bits for communicating reset commands/status between MCU
and host. Also add an extra initial reset command.
Signed-off-by: Felix Fietkau <[email protected]>
After DMA reset, tx status information for queued frames will never arrive.
Flush the queue to free skbs immediately instead of waiting for a timeout
Signed-off-by: Felix Fietkau <[email protected]>
We should use ieee80211_free_txskb() to report skb status avoid wrong
aql accounting after reset.
Cc: [email protected]
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
In mt7615_mac_reset_work(), make sure freeing skbs after mt7615_dma_reset().
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
mt7615_tx_token_put() should get call before mt76_free_pending_txwi().
Fixes: a6275e934605 ("mt76: mt7615: reset token when mac_reset happens")
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Ensures that header translation is disabled for interfaces that do not support
it.
Fixes: bb1262e7199b ("mt76: mt7615: add support for rx decapsulation offload")
Signed-off-by: Felix Fietkau <[email protected]>
Resolve the following checkpatch.pl script warning:
WARNING: Missing or malformed SPDX-License-Identifier tag in line 1
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Frame reception timestamp (low 32-bits) that indicates the value of the
local TSF timer value at the time the first bit of the MAC header in the
received frame (PPDU unit) arriving at the MAC.
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
ieee80211_beacon_get_template() returns NULL when beacon state is disabled,
so beacon_offload cannot be disabled for some devices.
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Similar to mt7921 driver, make sure the mcu is not in sleep mode before
sending mcu messages in mt7615_remove_interface routine.
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
There is a error message within devm_ioremap_resource
already, so remove the dev_err call to avoid redundant
error message.
Reported-by: Hulk Robot <[email protected]>
Signed-off-by: Guobin Huang <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
After chip reset, the DMA scheduler needs to be initialized as well.
Since the code is PCI/SoC specific, move it to pci_mac.c, so that it
can depend on a function in dma.c
Signed-off-by: Felix Fietkau <[email protected]>
BSS_INFO_BASIC is never called alone with inactive state, which always
follows beacon offload disable, so keep it enabled throughout interfaces
life cycle. Inactive state also removes sta record of all connected
stations, thurs causes connection lost which defeats the purpose of CSA.
Lastly, this is especially an unexpected behavior that keeping mt7622
failing beacon buffer recyled when scanning channels.
bss_conf change is updated with active state only, so just overwrite it.
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
hif interrupt needs to be triggered after MT_MCU_INT_EVENT.
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
With this patch, mt7615_mac_reset_work() can recover system back.
Fixes: e637763b606b ("mt76: move mcu queues to mt76_dev q_mcu array")
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Introduce mt76_sta_cmd_info data structure to contain parameters passed
to mt76_sta_cmd_info routine. This is preliminary patch to properly
configure rcpi for mt7921 devices.
Signed-off-by: Lorenzo Bianconi <[email protected]>
Fix format changes among the firmware versions.
Fixes: f9390c251868 ("mt76: mt7615: fix CSA notification for DBDC")
Signed-off-by: Ryder Lee <[email protected]>
Use the additional memory barrier to ensure the skb list up-to-date
between the skb producer and consumer to avoid the invalid skb content
written into sdio controller and then cause device hang due to mcu assert
caught by WR_TIMEOUT_INT.
Fixes: 1522ff731f84 ("mt76: mt7663s: introduce sdio tx aggregation")
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Each packet should be padded with the additional zero to become 4-bytes
alignment in sdio tx aggregation.
Fixes: 1522ff731f84 ("mt76: mt7663s: introduce sdio tx aggregation")
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
HW beacon filter command is being applied until we're in associated state
because the command would rely on the associated access point's beacon
interval and DTIM information.
Fixes: 7124198ab1a4 ("mt76: mt7615: enable beacon filtering by default for offload fw")
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Properly check returned values from mcu utility routines in
mt7615_ops.
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
In order to properly report MIB counters to mac80211, resets stats in
mt7615_get_stats routine and hold mt76 mutex accessing MIB counters.
Sum up MIB counters in mt7615_mac_update_mib_stats routine.
Fixes: c388d8584bc83 ("mt76: mt7615: add a get_stats() callback")
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Only mt7615 uses v1 version. Also, some of released firmware doesn't
have hdr->fw_ver.
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
The index of TSF counters should follow HWBSSID.
Fixes: cd79526761 ("mt76: mt7615: support 16 interfaces")
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Similar to the issue fixed in mt7921_coredump_work, fix a possible memory
leak in mt7615_coredump_work routine.
Fixes: d2bf7959d9c0f ("mt76: mt7663: introduce coredump support")
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
For AP and Client mode, the hardware can pass received packets
as 802.3 frames that can be passed to the network stack as-is.
Tested-by: Frank Wunderlich <[email protected]>
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Set skb->ip_summed to CHECKSUM_UNNECESSARY if the hardware has validated
the IP and TCP/UDP checksum
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Enable hw rx-amsdu de-aggregation support.
This is a preliminary patch to enable rx checksum offload.
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
Update sched_scan command usage according to the current firmware
submitted into linux-firmware.git.
Fixes: 80fc1e37c0eb ("mt76: mt7921: rely on mt76_connac_mcu module for sched_scan and hw_scan")
Co-developed-by: Soul Huang <[email protected]>
Signed-off-by: Soul Huang <[email protected]>
Signed-off-by: Sean Wang <[email protected]>
Signed-off-by: Lorenzo Bianconi <[email protected]>
Signed-off-by: Felix Fietkau <[email protected]>
