sync with upstream changes

Signed-off-by: Felix Fietkau <[email protected]>

agg-rx.c

@@ -290,8 +290,8 @@ void mt76_rx_aggr_stop(struct mt76_dev *dev, struct mt76_wcid *wcid, u8 tidno)
 {
 	struct mt76_rx_tid *tid = NULL;
 
-	rcu_swap_protected(wcid->aggr[tidno], tid,
+	tid = rcu_replace_pointer(wcid->aggr[tidno], tid,
-			   lockdep_is_held(&dev->mutex));
+				  lockdep_is_held(&dev->mutex));
 	if (tid) {
 		mt76_rx_aggr_shutdown(dev, tid);
 		kfree_rcu(tid, rcu_head);

eeprom.c

@@ -97,7 +97,7 @@ mt76_eeprom_override(struct mt76_dev *dev)
 	if (np)
 		mac = of_get_mac_address(np);
 	if (!IS_ERR_OR_NULL(mac))
-		memcpy(dev->macaddr, mac, ETH_ALEN);
+		ether_addr_copy(dev->macaddr, mac);
 #endif
 
 	if (!is_valid_ether_addr(dev->macaddr)) {

mac80211.c

@@ -2,7 +2,7 @@
 /*
  * Copyright (C) 2016 Felix Fietkau <[email protected]>
  */
-#include <uapi/linux/sched/types.h>
+#include <linux/sched.h>
 #include <linux/of.h>
 #include "mt76.h"
 
@@ -454,7 +454,6 @@ EXPORT_SYMBOL_GPL(mt76_alloc_device);
 int mt76_register_device(struct mt76_dev *dev, bool vht,
 			 struct ieee80211_rate *rates, int n_rates)
 {
-	struct sched_param sparam = {.sched_priority = 1};
 	struct ieee80211_hw *hw = dev->hw;
 	struct mt76_phy *phy = &dev->phy;
 	int ret;
@@ -489,7 +488,7 @@ int mt76_register_device(struct mt76_dev *dev, bool vht,
 		return ret;
 
 	WARN_ON(mt76_worker_setup(hw, &dev->tx_worker, NULL, "tx"));
-	sched_setscheduler(dev->tx_worker.task, SCHED_FIFO, &sparam);
+	sched_set_fifo_low(dev->tx_worker.task);
 
 	return 0;
 }

mt7603/Makefile

@@ -1,15 +1,6 @@
+# SPDX-License-Identifier: GPL-2.0-only
 EXTRA_CFLAGS += -Werror -DCONFIG_MT76_LEDS
-
+obj-m += mt7603e.o
-CHECK_CC_ENUM_FLAGS = $(NOSTDINC_FLAGS) $(LINUXINCLUDE) $(KBUILD_CPPFLAGS) $(KBUILD_CFLAGS)
-CHECK_CC_ENUM_FLAGS += -DKBUILD_MODNAME='"mt7603e"'
-check-cc-enum = $(call try-run, echo "int v = $(1);" | $(CC) -Werror $(CHECK_CC_ENUM_FLAGS) $(2) -c -x c - -o "$$TMP",y,n)
-
-# backwards compatibility hack
-ifeq ($(call check-cc-enum,IEEE80211_HW_TX_STATUS_NO_AMPDU_LEN,-include net/mac80211.h),n)
-  EXTRA_CFLAGS += -DIEEE80211_HW_TX_STATUS_NO_AMPDU_LEN=IEEE80211_HW_REPORTS_TX_ACK_STATUS
-endif
-
-obj-m := mt7603e.o
 
 mt7603e-y := \
 	pci.o soc.o main.o init.o mcu.o \

mt7603/soc.c

@@ -9,7 +9,6 @@
 static int
 mt76_wmac_probe(struct platform_device *pdev)
 {
-	struct resource *res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
 	struct mt7603_dev *dev;
 	void __iomem *mem_base;
 	struct mt76_dev *mdev;
@@ -20,7 +19,7 @@ mt76_wmac_probe(struct platform_device *pdev)
 	if (irq < 0)
 		return irq;
 
-	mem_base = devm_ioremap_resource(&pdev->dev, res);
+	mem_base = devm_platform_ioremap_resource(pdev, 0);
 	if (IS_ERR(mem_base))
 		return PTR_ERR(mem_base);
 

mt7615/debugfs.c

@@ -464,6 +464,7 @@ static const struct file_operations fops_ext_mac_addr = {
 	.llseek = generic_file_llseek,
 	.read = mt7615_ext_mac_addr_read,
 	.write = mt7615_ext_mac_addr_write,
+	.owner = THIS_MODULE,
 };
 
 static int

mt76x0/Makefile

@@ -1,3 +1,4 @@
+# SPDX-License-Identifier: GPL-2.0-only
 obj-$(CONFIG_MT76x0U) += mt76x0u.o
 obj-$(CONFIG_MT76x0E) += mt76x0e.o
 obj-$(CONFIG_MT76x0_COMMON) += mt76x0-common.o

mt76x2/Makefile

@@ -1,3 +1,4 @@
+# SPDX-License-Identifier: GPL-2.0-only
 obj-$(CONFIG_MT76x2_COMMON) += mt76x2-common.o
 obj-$(CONFIG_MT76x2E) += mt76x2e.o
 obj-$(CONFIG_MT76x2U) += mt76x2u.o

mt7915/mcu.c

@@ -1648,7 +1648,7 @@ mt7915_mcu_wtbl_ht_tlv(struct sk_buff *skb, struct ieee80211_sta *sta,
 		tlv = mt7915_mcu_add_nested_tlv(skb, WTBL_VHT, sizeof(*vht),
 						wtbl_tlv, sta_wtbl);
 		vht = (struct wtbl_vht *)tlv;
-		vht->ldpc = !!(sta->vht_cap.cap & IEEE80211_VHT_CAP_RXLDPC),
+		vht->ldpc = !!(sta->vht_cap.cap & IEEE80211_VHT_CAP_RXLDPC);
 		vht->vht = true;
 
 		af = FIELD_GET(IEEE80211_VHT_CAP_MAX_A_MPDU_LENGTH_EXPONENT_MASK,
@@ -2895,7 +2895,7 @@ int mt7915_mcu_init(struct mt7915_dev *dev)
 	};
 	int ret;
 
-	dev->mt76.mcu_ops = &mt7915_mcu_ops,
+	dev->mt76.mcu_ops = &mt7915_mcu_ops;
 
 	ret = mt7915_driver_own(dev);
 	if (ret)